# OpenSCAD files for my phone mount

<img src="./.assets/front.jpg" height=600 /> <img src="./.assets/back.jpg" height=600 />

### phone mount.scad

This is the part that clips on your phone. Adjust the following variables to fit your phone (use calipers to measure distances):

- depth
- height
- angle

<img src="./.assets/back-details.jpg" height=600 />

### base mount.scad

This is the piece that goes on your table. Adjust the following variables:

- table_thickness
- grabber_length

<img src="./.assets/front-details.jpg" height=600 />

I also recommend taping this down so it won't fall off if you bump it.

### rod.scad

The rod that connects the two pieces. Ideally you'd use something else that you already have instead of printing a long tube.

In the previous two files, you can adjust `hole_depth` to fit whatever you're using as rod. Make sure to add 1-2mm as tolerance.

I'm not using this specific model because I already had a fitting rod from a previous project, but I guess you can save yourself the 2 minutes to model one yourself.