1 KiB
1 KiB
OpenSCAD files for my phone mount
phone mount.scad
This is the part that clips on your phone. Adjust the following variables to fit your phone (use calipers to measure distances):
- depth
- height
- angle
base mount.scad
This is the piece that goes on your table. Adjust the following variables:
- table_thickness
- grabber_length
I also recommend taping this down so it won't fall off if you bump it.
rod.scad
The rod that connects the two pieces. Ideally you'd use something else that you already have instead of printing a long tube.
In the previous two files, you can adjust hole_depth to fit whatever you're using as rod. Make sure to add 1-2mm as tolerance.
I'm not using this specific model because I already had a fitting rod from a previous project, but I guess you can save yourself the 2 minutes to model one yourself.